Description of hot stamping machine for abs fridge profiles
Part 1. Application:
☆ This OTR100 Model hot stamping machine is special designed for decorating various PVC/PS/WPC/ABS/PVC foaming small profiles within 100mm widths; Now it is special used to decorating imitation marble stone profiles;
☆ Normally for PVC marble profiles, there have 5-9surfaces, so we always match 10sets of online hot stamping machine to get complete marble designs;
☆ For PS picture frame, it also need match 5-10sets, some for embossing, some for hot stamping, that will depended on the designs.
☆ It is installed on the extrusion line, before Haul-off machine and after calibration table;
☆ The center height of machine is 1000mm per center height of extrusion line.
Part2. The technical parameter of machine
Items |
Technical Parameters |
Part 3: Basic assembly of OTR100
3.1) Transmitting unit
① The whole machine adopts 50*50 square tube and Q235 steel plate to weld.
② It adopts angle iron to make conveying table.
③ It adopts cast iron wrapped with nylon to make conveying wheel.
④ It adopts nylon to control the width of board.
3.2) The angle adjustment unit
① It adopts Q235 steel plate to make base-plate, clipboard and joint-plank.
② It adopts Q235 steel plate to make big circle wheel.
③ It adopts 160 hand-wheel to adjust thermoprinting angle by worm wheel and worm.
3.3) The head of stamping control unit
① It adopts Q235 steel plate to make erect plank, plank of air cylinder; and 63*150 air cylinder to control the stamping head work back and forth.
② It adopts ZL102 with the copper slipcover to make guide thimble, and 45 steel for guide pole.
③ It adopts ZL102 to make slide seat, 45 steels for slide shaft and flat steel to make index plate.
3.4) The stamping head unit
① It adopts ZL102 to make heating cover and 2 stainless steel heating pump(650w/pc) for heating, the temperature is controlled by TC Panel.
It adopts 45 steels to make axle and seat of thermoprinting.
② It adopts ZL102 wrapped with anti high temperature silicon rubber to make stamping wheel.
3.5) winding & unwinding unit
① It adopts 45# steel to make shaft and Q235 to make joint plate.
② It adopts organic glass to make clamp for clamping film and aluminum loop to make fixed components.
③ It adopts 25w electronic timing gear speed-down motor to drive winding shaft by gears.
④ It adopts Q235 to make joint plate and 45# light&round steel to make shaft of guiding film.
3.6) Electric control unit
① It adopts cold rolled steel to make electric container.
② The electric components of equipment adopts famous brand in home market.
Part 4. Flow chart of OTR100
http://www.cnyudajixie.com/